wla 5WM2010M - User Manual

Questions and Answers

J
Julia ThompsonAug 17, 2025
Why does my wla 5WM2010M Washer vibrate?
- T
  Teresa RodriguezAug 17, 2025
  Your wla Washer might be vibrating due to several reasons: the feet of your machine may not be adjusted, so adjust them; safety stays fitted for transportation may not be disassembled, so disassemble them; the machine might be overloaded with laundry or laundry settled unevenly, so do not put in more laundry than recommended and settle it evenly; or your machine might be resting on a hard surface, so prevent it from doing so. Note that a less amount of laundry will not block operation of your machine.
H
Heather DaughertyAug 20, 2025
What to do if my wla 5WM2010M Washer does not discharge water?
- A
  Angie NolanAug 20, 2025
  If your wla Washer isn't discharging water, it could be due to a clogged or twisted discharging hose, so check the hose and either clean or untwist it. Another cause might be a clogged pump filter, so clean the pump filter. Additionally, laundry settled unevenly in the machine can cause this issue, so spread your laundry evenly.
R
Robert KellyAug 23, 2025
How to stop excessive foam in wla Washer detergent drawer?
- J
  John PorterAug 23, 2025
  Excessive foam in the detergent drawer of your wla Washer is likely due to using too much detergent or using the wrong detergent. To eliminate foam formation, mix a spoon of softener with half litres of water and pour the mixture in the detergent drawer. After 5-10 minutes, press the Start/Pause button again. In your next washing operation, adjust the detergent dose accordingly and ensure you are only using detergents produced for automatic washing machines.
D
Dr. Pamela DavisAug 26, 2025
Why is my wla Washer not washing clothes properly?
- H
  Howard PopeAug 26, 2025
  An unsatisfactory washing result from your wla Washer could be due to several reasons. The contamination degree of your laundries might not match the programme you have chosen, so select the appropriate programme. Also, the amount of detergent used might be insufficient, so adjust the amount based on the laundry amount and contamination degree. Finally, you might have put in laundries in excess of the maximum capacity, so ensure you do not exceed the maximum laundry capacity.
L
lloyddominiqueAug 28, 2025
What causes unsatisfactory washing results in wla 5WM2010M Washer?
- C
  Cesar JohnsonAug 28, 2025
  An unsatisfactory washing result from your wla Washer may occur if the water is hard (contaminated, lime water etc.), so adjust the amount of detergent based on the instruction of detergent manufacturer. It may also be caused by laundries distributed non-homogenously, so spread your laundries in the machine properly and homogeneously.
R
richard12Aug 31, 2025
Why are there grey spots on clothes after washing in wla 5WM2010M Washer?
- T
  Thomas TranAug 31, 2025
  If grey spots appear on your laundries after washing in your wla Washer, the reason may be oil, cream, or ointment. To address this, apply the maximum amount of detergent instructed by the detergent manufacturer in the next washing operation.
C
Carlos WestSep 3, 2025
Why wla 5WM2010M spinning operation is not working?
- J
  Julie ShortSep 3, 2025
  If the spinning operation in your wla Washer is not performed or runs late, it's likely not a fault. The unbalanced load control system has been activated and will try to spread your laundries homogeneously. The wringing operation will begin after your laundry is spread. Place the laundry in the machine in a balanced fashion the next time.
B
Brandy GarrettSep 5, 2025
What to do if wla 5WM2010M Washer door won't shut?
- C
  christinajordanSep 5, 2025
  Shut the door properly so that you hear the click. If the problem persists, turn off the machine unplug and apply to the nearest authorized service immediately.
M
megan76Sep 8, 2025
Why is the water level low in my wla Washer?
- B
  Brad SnyderSep 8, 2025
  Turn on the tap to the end. Water may be cut, check it. If the problem is still continuing, your machine will automatically stop after a while. Unplug your machine, turn off the tap and apply to the nearest authorized service.
T
Timothy MckinneySep 12, 2025
How to fix wla Washer pump failure?
- S
  sherry05Sep 12, 2025
  Clean the pump filter. If the problem persists, apply to the nearest authorized service.