EasyManua.ls Logo

wla 6WM1000M - User Manual

wla 6WM1000M
104 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

NL


Table of Contents

Questions and Answers

  • D
    Daisy PatelAug 15, 2025
    Why my wla 6WM1000M Washer does not start?
    • M
      Matthew WatkinsAug 16, 2025
      Your wla Washer might not start due to several reasons: it may not be plugged in, the fuses could be faulty, there might be no mains power supply, the Start/Pause button might not be pressed, the programme dial might be in the ‘stop’ position, or the machine door might not be completely closed. Ensure the machine is plugged in, check and replace the fuses if necessary, verify the mains power supply, press the Start/Pause button, turn the programme dial to the desired position, and make sure the machine door is fully closed.
  • C
    Christina ValenzuelaAug 18, 2025
    What to do if wla 6WM1000M Washer vibrates?
    • G
      Gregory RobinsonAug 18, 2025
      If your wla Washer is vibrating, it could be due to several reasons. Check if the feet have been adjusted and adjust them if necessary. Ensure that the transit bolts fitted for transportation have been removed. Also, avoid overloading the drum and spread the laundry evenly. Make sure that the washing machine is not set up on a hard surface.
  • K
    Katherine SanchezAug 21, 2025
    Why my wla Washer does not intake water?
    • J
      jacksonpaulAug 22, 2025
      If your wla Washer isn't taking in water, the water tap might be turned off; make sure to turn it on. The water inlet hose could be twisted, so check and untwist it. The water inlet hose or inlet filter might be clogged; clean them. Lastly, ensure the machine door is completely closed.
  • G
    gflowersAug 25, 2025
    What to do if wla 6WM1000M Washer doesn't discharge water?
    • J
      John OwensAug 25, 2025
      If your wla Washer isn't discharging water, the drain hose might be clogged or twisted; inspect, clean, or untwist it. The pump filter could be clogged, so clean it. Also, ensure your laundry isn't too tightly packed in the drum; spread it evenly.
  • C
    carolynsinghAug 27, 2025
    Why is there excessive foam in the detergent drawer of my wla 6WM1000M Washer?
    • P
      pamelarodriguezAug 27, 2025
      Excessive foam in the detergent drawer of your wla Washer is likely due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer, then press the Start/Pause button again after 5-10 minutes. Ensure you only use detergents specifically produced for automatic Washing Machines.
  • W
    william20Aug 30, 2025
    Why is my wla Washer laundry has detergent residue?
    • T
      Tammy GonzalezAug 31, 2025
      Non-dissolving particles of some detergents may appear on your laundry as white spots. Perform an extra rinse, or clean your laundry with a brush after it dries.
  • A
    Amber DuncanSep 2, 2025
    Why my wla 6WM1000M washing result is unsatisfactory?
    • J
      Jeffrey MoranSep 2, 2025
      An unsatisfactory washing result from your wla Washer could be due to several factors. The washing might be too dirty for the selected program, so select a more appropriate program. You might not be using enough detergent, so use the amount instructed on the packaging. Or, there might be too much laundry in your machine, so check that you have not exceeded the maximum capacity for the selected program. Hard water or tightly packed laundry can also cause this issue; increase detergent or spread out the laundry.
  • D
    dobrienSep 5, 2025
    Why does my wla 6WM1000M Washer laundry has grey spots?
    • A
      Amy WhitakerSep 5, 2025
      If grey spots appear on your laundry after washing in your wla Washer, it may be because there is untreated oil, cream, or ointment on your laundry. Use the amount of detergent as instructed on the packaging in the next wash.
  • D
    David RogersSep 8, 2025
    What to do if wla 6WM1000M is loaded with water, water discharges immediately?
    • J
      Jeffrey MarksSep 8, 2025
      If water discharges as soon as your wla Washer is loaded, it's likely that the end of the water drain hose is too low. Check that the drain hose is at a suitable height.
  • D
    Danielle BrownSep 12, 2025
    Why the spin cycle of my wla Washer does not take place?
    • L
      lancemontoyaSep 12, 2025
      If the spin cycle in your wla Washer does not take place or is delayed, it may be because the Unbalanced load control system has been activated. This system will try to spread your laundry. The spinning cycle will begin once your laundry is spread. Load the drum evenly for the next wash.

Summary

Safety Instructions

General Safety Warnings

Provides essential safety guidelines for proper machine operation and user protection.

Technical Specifications

General Appearance

Overview of the machine's external design and components.

Technical Specifications

Key operational data including voltage, power, capacity, and dimensions.

Installation

Transit Bolt Removal

Instructions for removing transit bolts before first use to prevent vibration and damage.

Leveling the Machine

Guide on adjusting feet to ensure the machine is stable and level.

Connecting to Power Supply

Steps for safe electrical connection to the mains.

Water Inlet Hose Setup

How to correctly connect the water supply hose to the machine's inlet valve.

Drain Hose Connection

Proper installation of the drain hose for water discharge.

Washing Machine Control Panel

Detergent Drawer Compartments

Explains the different sections of the detergent drawer and their uses.

Detergent Drawer Sections

Details the specific compartments for detergent, softener, and pre-wash.

Program Dial Operation

How to select and set wash programs using the main dial.

Electronic Display Guide

Interpretation of symbols and indicators shown on the electronic display panel.

Operating Your Washing Machine

Laundry Preparation

Guidance on sorting laundry by type, color, and dirt level.

Loading Laundry Correctly

Instructions for evenly loading laundry into the drum.

Detergent and Softener Usage

Recommendations for the type and quantity of detergent and softener.

Starting a Wash Cycle

Step-by-step process to start the washing machine.

Choosing Wash Programs

How to select the most suitable wash program for your laundry needs.

Half-Load Detection Feature

Explains the automatic half-load system for water and energy saving.

Additional Functions

Overview of extra functions like Delay Timer, No Spin, and Anti-Allergic.

Child Lock Feature

Instructions for activating and deactivating the child lock for safety.

How to Cancel a Program

Procedure to stop and cancel a running wash program.

Program Completion and Unloading

Information on finishing a cycle, opening the door, and unloading laundry.

Wash Program Guide

Important Program Notes

Critical information and tips related to wash program durations and settings.

Machine Cleaning and Care

Maintenance Safety Precautions

Essential safety warnings before performing any cleaning or maintenance.

Cleaning Water Inlet Filters

Steps to locate, clean, and re-insert the water inlet filters.

Pump Filter Maintenance

Guide on how to clean the pump filter for optimal performance.

Detergent Drawer Cleaning

Instructions for removing and thoroughly cleaning the detergent drawer.

Cleaning Machine Parts

Troubleshooting Common Issues

Understanding Error Codes

wla 6WM1000M Specifications

General IconGeneral
Current10 A
Connected load2100 W
AC input voltage220 - 240 V
Power consumption (off)0.5 W
Power consumption (standby)1 W
Water consumption per cycle43 L
Energy consumption washing per cycle0.95 kWh
Annual water consumption washing9990 L
Annual energy consumption washing171 kWh
Drum capacity6 kg
Cycle time (max)200 min
Delay start (max)12 h
Residual moisture62 %
Spin-drying classC
Maximum spin speed1000 RPM
Noise level (spin)77 dB
Noise level (wash)58 dB
Load balancing systemNo
Adjustable temperatureYes
Number of washing programs15
Package depth547 mm
Package width641 mm
Package height881 mm
Door hingeLeft
Water fillCold
Drum volume45 L
Control typeButtons, Rotary
Loading typeFront-load
Product colorWhite
Appliance placementFreestanding
Weight and Dimensions IconWeight and Dimensions
Depth497 mm
Width597 mm
Height845 mm
Weight45000 g

Related product manuals