What to do if my WM aquatec Water Filtration Systems has no function/no LED signal?
If your WM aquatec Water Filtration System has no function and no LED signal, first, verify the electrical connections, because there may be no power supply or a faulty connection. If the issue persists, the product may be defective; in this case, disassemble the UV-unit and send it to the dealer or manufacturer.
How to fix temperature error in WM aquatec UV-C LED Water Filtration Systems?
If you're getting a temperature error with your WM aquatec Water Filtration Systems, it could be due to the water temperature being too high and/or the flow rate being too low, or there may be no water in the tank or pipes. First, check the water temperature and increase the flow rate if needed. If that doesn't work, fill the tank/pipes with water.
What to do if WM aquatec UV-C LED has leakage (leaks)?
If your WM aquatec Water Filtration Systems is leaking, it could be due to a defective product or leaky water pipes/water connections. Check the installation of water pipes and connections. If the leakage continues, disassemble the UV-unit and send it to the dealer or manufacturer.
General| Lamp Life | Up to 10, 000 hours |
|---|---|
| Input Voltage | 12V DC |
| Type | UV-C LED Water Sterilizer |
| UV-C LED Wavelength | 270-280 nm |
| Housing Material | Stainless Steel |
To Next Page
