RF Exposure Information
This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation, the
maximum antenna gain including cable loss in a mobile exposure condition must not exceed:
Standalone Condition:
。 8.0 dBi in 700 MHz Band
。8.0 dBi in 850 MHz Band
。5.0 dBi in 1700 MHz Band
。7.5 dBi in 1900 MHz Band
Assuming collocated with a WLAN transmitter with maximum 27 dBm average EIRP power
。 7.0 dBi in 700 MHz Band
。5.0 dBi in 850 MHz Band
。5.0 dBi in 1700 MHz Band
。7.5 dBi in 1900 MHz Band
Remark: This assumption is not valid if the output power of the collocated WLAN transmitter is higher than 27 dBm.
IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement
of the end product, which integrates this module. 20cm minimum distance has to be able to be maintained between
the antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation
exposure limits set forth for an population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate
this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency
exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any
changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this
equipment. If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required
To Next Page
Loading...
Need help?
General
