Need help?Do you have a question about the Wolf 15" and is the answer not in the manual?
Highlights information that is especially important for safe and efficient use of Wolf equipment.
Signals situations where minor injury or product damage may occur if instructions are not followed.
States hazards that may cause serious injury or death if precautions are not followed.
Installation must be done by a qualified installer or Wolf factory certified service, following all codes.
Details on locating the model and serial numbers on the product rating plate.
Overall dimensions for framed and unframed induction cooktops in 15", 30", and 36" sizes.
Overall dimensions for framed and unframed electric cooktops in 15", 30", and 36" sizes.
Details power supply, service, and max connected load for various induction and electric cooktop models.
Emphasizes proper grounding, use of separate ground wire, and handling of aluminum house wiring.
Specifies cabinet width recommendations and minimum clearances for safe operation and ventilation.
Recommends using Wolf cooktop ventilation hoods or downdraft systems for optimal performance.
Illustrates conduit dimensions required for installation.
Diagram showing side clearance and cabinet depth requirements for a 15" framed cooktop.
Diagram showing front clearances and cabinet width for a 15" framed cooktop.
Specifies the required width and depth for the countertop cut-out for a 15" cooktop.
Diagram showing side clearance and cabinet depth requirements for a 30" framed cooktop.
Diagram showing front clearances and cabinet width for a 30" framed cooktop.
Specifies the required width and depth for the countertop cut-out for a 30" cooktop.
Diagram showing side clearance and cabinet depth requirements for a 36" framed cooktop.
Diagram showing front clearances and cabinet width for a 36" framed cooktop.
Specifies the required width and depth for the countertop cut-out for a 36" cooktop.
Diagram showing side clearance and cabinet depth for flush mount of a 30" unframed cooktop.
Diagram showing front clearances for flush mount of a 30" unframed cooktop.
Details recess and cut-out dimensions for flush mounting a 30" unframed cooktop.
Diagram showing side clearance and cabinet depth for flush mount of a 36" unframed cooktop.
Diagram showing front clearances for flush mount of a 36" unframed cooktop.
Details recess and cut-out dimensions for flush mounting a 36" unframed cooktop.
Guidelines for installing multiple cooktops, including filler strips and electrical circuits.
Describes flush mounting and frameless installation options for unframed cooktops.
Warns that flush mount installations are for specific countertop materials and can be damaged by hot cookware.
Details creating a recessed area around the cut-out for flush mounting, using a plywood template.
Describes attaching L-shaped cleats to support the unframed cooktop for flush mounting.
Instructions for attaching the foam strip to the cooktop frame or glass-ceramic top.
Details on lowering, centering, and securing the cooktop using installation brackets and screws.
Important note advising against sealing the cooktop to the countertop for serviceability.
Read use & care guide, clean surface, and verify controls and element operation.
Notes that a small amount of smoke and odor may be noticed during the initial break-in period.
Do not operate if the glass-ceramic surface is broken; contact factory certified service.
Disconnect power, remove brackets, and remove cooktop. Reinstall in reverse order.
For flush mounts, cut perimeter seal with a razor blade; requires a new RTV kit for reinstallation.
Steps to verify power, check connections, and refer to use & care guide for operation issues.
How to find and contact Wolf factory certified service, and information needed when calling.
To Next Page
General
