EasyManua.ls Logo

Wolf CE152TF/S - Page 14

Wolf CE152TF/S
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 14
Integrated Modules
Integrated Modules
Electronics and Gas Theory
2-4
#826498 - Revision B - December, 2016
Timer
General Information - All Models
Available in any mode except Lock Mode, Sabbath mode, User Option mode, and Diagnostic mode.
The 2-digit display is blank unless there is a fault, in Diagnostic mode, or in Showroom mode.
Shows minutes until the timer reaches 1 minute.
Switches to seconds at 1 minute, and counts down from 60 seconds.
Timer is paused until 3 seconds after the last change in value then countdown begins.
Adjusting the time on a running timer resets the seconds to zero.
If counting down seconds and the “-” pad is touched the timer stops without alarm.
Maximum time allowed is 99 minutes.
Minimum time allowed is 1 minute.
Timer turns off after 10 seconds if no time is entered.
Starting the Timer - All Models
1. Unlock the unit.
2. Press and release the TIMER pad.
3. Time increases and decreases with a touch of the “+” or “-” pad.
If the “+” or “-” pad is held continuously for 3 intervals the count rate increases.
If the “+” or “-” pad is held continuously for additional 3 intervals, the count rate increases again.
A continuously held “+” or “-” increases in this manner: 00, 01, 02, 03, 04, 05, 10, 15, 20, 30, 40, 50,
60, 70, 80, 90, 99.
Ending the Timer - All Models
Touch of the TIMER or “-” pad stops Timer Complete beep and clears the display.1.
At 60 seconds the One Minute Remaining beep sounds.
At 00 the Timer Complete beep sounds until acknowledged.
Touch of the “+” pad adds time to the timer as described above.2.
Display States of the Timer - All Models
When active the 2-digit display and Timer are on.
Other displays are as described in Idle Mode or Operational Mode.
Fan
Fan - CE152TF/S
Fan control is determined by the temperature on the heat sink.
After element assemblies are off fan continues to run until heat sink temperature is below 113° F, or up to
600 seconds.
Fan is limited to low speed when the element assemblies are off.
Temperature thresholds:
113° F – start low speed
131° F – start high speed

Related product manuals