Integrated Modules
Integrated Modules
Troubleshooting
4-6
#826498 - Revision B - December, 2016
f. Error Code Indicator - CE152TF/S, CI152TF/S and TM15TF/S
Touch “+” pad during the Coil Temperature test. 1
CE152TF/S and CI152TF/S - six “.” are displayed on rear control zone.•
TM15TF/S - six “.” are displayed on front control zone.•
CE152TF/S and CI152TF/S - front control zone shows 0-8 dimmed “.” based on how many error codes•
are logged.
TM15TF/S - rear control zone shows 0-8 dimmed “.” based on how many error codes are logged.•
Fully lit LED indicates which error is being displayed in the 2-digit display. •
If only a single error has been logged, only a single fully lit LED is displayed. •
If no errors logged SIM/MLT/LO, HI, and “.” are not displayed and “- -” is displayed in the 2-digit display. •
2-digit display shows the corresponding error code stored in memory. •
Rear SIM/MLT/LO and HI are dimmed. A touch of the front control zone SIM/MLT/LO or HI pads cycles2
through the stored error codes.
Touch and hold TIMER pad for 5 seconds to clear error code history. 3
Clearing the error code history is only possible if at least one error was logged. •
Clearing the error code history is confirmed by a double beep. •
If an error is currently present when the log is cleared, it immediately regenerates an error code. •
“-” pad returns to Coil Temperature test and “+” pad advances to Showroom Mode menu.4
f. Error Code Indicator - SM15TF/S, FM15TF/S and GM15TF/S
Touch “+” pad during the RTD Temperature test. 1
Five “.” are displayed on rear control zone.•
Front control zone shows 0-8 dimmed “.” based on how many error codes are logged•
Fully lit LED indicates which error is being displayed in the 2-digit display. •
If only a single error has been logged, only a single fully lit LED is displayed. •
If no errors logged LO, and HI, and “.” are not displayed and “- -” is displayed in the 2-digit display. •
2-digit display shows the corresponding error code stored in memory. •
A touch of the front control zone LO or HI pads cycles through the stored error codes. 2
Touch and hold TIMER pad for 5 seconds to clear error code history. 3
Clearing the error code history is only possible if at least one error was logged. •
Clearing the error code history is confirmed by a double beep. •
If an error is currently present when the log is cleared, it immediately regenerates an error code. •
“-” pad returns to RTD Temperature test and “+” pad advances to Showroom Mode menu4
g. Showroom Mode - CE152TF/S, CI152TF/S, and TM15TF/S
Touch “+” pad during the Error Code Indicator. 1
CE152TF/S and CI152TF/S - Seven “.” displayed on rear control zone.•
TM15TF/S - Seven “.” displayed on front control zone.•
To engage showroom mode.2
CE152TF/S and CI152TF/S - touch the front control zone HI pad to engage showroom mode.•
TM15TF/S - touch the rear control zone HI pad to engage showroom mode.•
SH is displayed in the 2-digit display when in showroom mode.•
To disengage showroom mode.3
CE152TF/S and CI152TF/S - touch the front control zone SIM/MLT pad. •
TM15TF/S - touch the rear control zone LO pad.•
”-” pad returns to Error Code indicator and “+” pad advances to Software Version indicator.4
To Next Page
Loading...
