4 | Wolf Customer Care 800.222.7820
GENERAL SAFETY PRECAUTIONS
• Sucient air is needed for proper combus-
tion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting.
• Follow the heating equipment manufacturer’s
guideline and safety standards such as those
published by the National Fire Protection Asso-
ciation (NFPA), the American Society for Heat-
ing, Refrigeration and Air Conditioning Engi-
neers (ASHRAE), and the local code authorities.
• Do not operate any fan with a damaged cord
or plug. Discard fan or return to an authorized
service facility for examination and/or repair.
• This appliance must be grounded.
• Ducted fans must always be vented to the
outdoors.
CAUTION
For general ventilating use only. Do not use
to exhaust hazardous or explosive materials
and vapors.
CAUTION
To reduce the risk of fire and properly
exhaust air, be certain to duct air outside. Do
not vent exhaust air into spaces within walls
or ceilings or into attics, crawl spaces, or
garages.
IMPORTANT INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
• Read this use and care guide carefully before
using your new downdraft ventilation to reduce
the risk of fire, electric shock, or injury to per-
sons.
• Ensure proper installation and servicing. This
appliance must be properly installed and
grounded by a qualified technician.
• Warranty service must be performed by Wolf
Factory Certified Service.
• Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction codes and standards.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a) Use this unit only in the manner intended
by the manufacturer. If you have questions,
contact the manufacturer.
b) Before servicing or cleaning unit, unplug
the appliance or switch power o at service
panel and lock the service disconnecting
means to prevent power from being
switched on accidentally. When the service
disconnecting means cannot be locked,
securely fasten a prominent warning
device, such as a tag, to the service panel.
c) Do not use replacement parts that have
not been recommended by the manufac-
turer (e.g. parts made at home using a 3D
printer).
Safety Precautions
To Next Page
Loading...
