58
WOLF COOKTOP VENTILATION
ELECTRICAL REQUIREMENTS
Wolf E Series cooktop wall and island hoods
require a separate, grounded 220-240 V AC,
50/60 Hz power supply with a dedicated 15 amp
circuit. Placement of the electrical supply is not
critical, as long as it is accessible
Locate electrical within the shaded area shown
in the Installation Specifications illustration for
your model.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and may
cause interruption of operation.
You must follow all local codes and ordinances
when installing your service.
PLANNING INFORMATION
Wolf E Series cooktop wall hoods are 450 mm
deep and come in 762 mm, 914 mm and 1143
mm widths. The island hood is 1067 mm wide
by 550 mm deep. (I) models include a 500 CFM
internal blower.
IMPORTANT NOTE: E Series cooktop wall and
island hoods are recommended for use with
Wolf electric and gas cooktops along with inte-
grated modules, and should be at least as wide
as the cooking surface.
Wolf E Series cooktop wall and island hoods
come with a telescopic flue that allows you to
reach a ceiling height of 2.4 m to 2.7 m with a
finished look.
Specifications on the following pages provide
overall dimensions, blower and ducting consider-
ations, and installation specifics for cooktop
wall and island hoods. We have minimized the
information contained in the illustrations,
concentrating on the critical information you
must plan into your installation.
Installation of the cooktop wall or island hood
should be 650 mm to 760 mm from the bottom
of the hood to the countertop.
ACCESSORIES
E Series Cooktop Hoods
Internal and remote blower
assemblies
Charcoal filters for non-ducted
applications (internal blower
(I) models only)
Accessories are available through
your Wolf dealer.
To Next Page
Loading...
