Warming Drawer Care 12
Troubleshooting
I
f your Wolf warming drawer is not operating properly, use
the following troubleshooting guide before calling your
Wolf authorized service center. This guide will save you
time and trouble and may help you avoid the expense of a
service call.
Warming drawer does not operate.
• Check the household fuse or circuit breaker to see if it
has been blown or tripped. A power outage may also
have caused a disruption in service.
• Verify that the electrical connection to the warming
drawer has not been disconnected.
Drawer does not slide smoothly.
• Ball bearings are out of alignment. Fully extend the
drawer and close completely to realign.
• Drawer is overloaded or the load is unbalanced.
Reduce weight to less than 75 lbs (34 kg) or
redistribute contents.
There is excessive condensation.
• Remove liquid in the warming drawer pan.
• Cover food with a lid or aluminum foil.
• Temperature setting is too high, use a lower setting.
No heat in the proof setting.
• Room temperature may prevent the thermostat from
turning on. Verify that PROOF is illuminated in the
display on the control panel.
Food dries out in the proof setting.
• Cover food with a lid or aluminum foil.
Care Recommendations
IMPORTANT NOTE: M
ake sure the warming drawer is
off and all surfaces are cool before cleaning any part of
the unit.
STAINLESS STEEL SURFACES
IMPORTANT NOTE:
Do not use abrasive cleaners; they will
permanently scratch stainless steel surfaces. Salt and
some cooking liquids may pit and stain the surface.
Remove these spatters immediately.
Use a spray degreaser to remove fingerprints and greasy
spatters. Spray on a cloth and wipe the surface. Buff dry
immediately to avoid streaking. For hard water stains, use
white vinegar and water.
For general cleaning, use a soft, nonabrasive stainless
steel cleaner like Signature polish and apply with a soft
lint-free cloth. To bring out the natural luster, lightly wipe
the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. All work should
follow the grain direction of the finish. Better results are
obtained by keeping the cloth in continuous contact with
the stainless steel.
Signature polish is available from Signature Limited
Laboratory, P. O. Box 13436, Dayton, Ohio 45413, or call
877-376-5474.
CONTROL PANEL
Use a spray degreaser to remove fingerprints and greasy
spatters. Spray on a cloth and wipe the surface. Use a
clean cloth or sponge and wipe the surface with warm
water and a mild detergent. Rinse and dry immediately.
IMPORTANT NOTE: Be careful not to soak the control
panel. Although the panel is sealed, excessive moisture
may cause damage to the controls.
To Next Page
Loading...
Need help?
General
