39
Reset setup
This is used to restore factory settings.
When reversing, the reversing line will automatically appear on the screen, and the screen will
automatically be pressed down 15° horizontally. However, due to the different installation
location of each guest, manual adjustment is required.
Reversing line (Auxiliary function)
If your car does not have a reversing system and you need a backup reversing system as an
aid, you need to connect the red cable of the rear cam to the positive pole of your reversing
lamp. If your car already has a reversing system, you just ignore the red cable on the rear cam.
When you shift to "r" gear, the rear view will automatically show on the screen with reversing
lines for easy and safe parking. You can enter the "Reversing line" option in the settings, then
adjust the angle of the reversing image and the reversing line. Also when in reversing, you can
adjust the viewing angle of the image. (This function activate after the red wire of the rear
camera be connected to the positive pole of the reversing light.)
To Next Page
Loading...
