Wolfman Enduro - User Manual

To Next Page

4 Point harness mounting instructions for all 2020 Wolfman Enduro (TB-2) and

Blackhawk (TB-3) Tank Bags. Thank you for your Purchase

FIG1 Enduro Tank Bag FIG2 Blackhawk Tank Bag

All the bags mentioned use the same method to attach to your motorcycle.

**Before you begin, make sure your gas tank and bag are free of dirt and grime. If you have a painted tank, we

recommend you wash and wax. Also clean the frame tubes, and underside of frame behind the steering tube. **

1-Front Harness

The front harness: 1-long 1” webbing strap, 1-short elastic keeper, 2-1” male buckles. FIG3

FIG3

2- Separate one, 1” buckle from the mounting strap and pull the webbing through the elastic keeper. Thread the

long 1” mounting strap under the frame, behind the steering tube, behind any wires and hoses at the sides (see

arrow), thread through the elastic keeper and the 1” male buckle.

FIG4 Side view FIG5 Top view

Need help?

Do you have a question about the Wolfman Enduro and is the answer not in the manual?

Summary

Ensure gas tank, bag, and frame tubes are clean. Wash and wax painted tanks. Clean frame tubes and underside.

Details the components of the front harness: one long webbing strap, one short elastic keeper, and two male buckles.

Details the components of the rear harness: two 23-inch mounting straps, one long elastic keeper, and two male buckles.

General