Setup
Initial setup of upper cutter
Setup doc081920 3-12
3
See Figure 3-6.
The upper horizontal cutter should be parallel to the machine table. This is set from fac-
tory, but the setting can become maladjusted by rough handling during transport or by the
machine being subject to impact.
1. Loosen the screws of the bearing housings a couple of turns (two M6, and two M8 on
each side).
2. Placing an absolutely level block on the machine table directly under the cutter head.
3. Turn the cutter head so that the block will not press against the knives or the knife slots.
4. Turn the crank that adjusts the machine table height (front, right corner of machine), so
that the block slightly lifts the cutter head.
5. Tighten the screws of the bearing housings.
IMPORTANT! When the bearing housings of the upper cutter have
been adjusted, or when the takeoff of the planing knives has been
changed, the position of the rotating scale must be calibrated. The
height scale indicator on the front side of the machine may also need
adjustment.
FIG. 3-6
TOP VIEW
Lower Cutter
Upper cutter
To Next Page
Loading...
