Wood Stone MOUNTAIN Series

Other manuals for Wood Stone MOUNTAIN Series

Service Manual56 pages

Questions and Answers

A
Adrienne BowersJul 28, 2025
What to do if my Wood Stone MOUNTAIN Oven controller will not turn on?
- E
  Evan HopkinsJul 28, 2025
  If the controller on your Wood Stone Oven doesn't turn on, first verify that the incoming power to the oven is active. Check the circuit breaker for the circuit that supplies power to the oven. Also, ensure that any external wall switches or interlocks controlling the oven's power are turned on. If the controller still does not turn on, please contact Wood Stone for assistance.
K
Kelly StarkAug 3, 2025
Why is the underfloor burner not running on my Wood Stone MOUNTAIN Oven?
- A
  Adam OrozcoAug 3, 2025
  The underfloor burner might not be running on your Wood Stone Oven because the hearth temperature is above the Hearth Set Point.
B
Brandy NicholsAug 8, 2025
What to do if I see a 'Chec' display on my Wood Stone Oven Controller?
- L
  Lauren KingAug 9, 2025
  If you see a 'Chec' display on your Wood Stone Oven controller, it means the underfloor burner did not ignite when the floor temperature dropped below the Hearth Set Point. Contact Wood Stone for assistance.
A
Adam JacksonAug 15, 2025
How to fix a Wood Stone Oven when the display does not light?
- A
  aharrisonAug 15, 2025
  If the display on your Wood Stone Oven doesn't light up, the first thing to check is whether the breaker to the oven has tripped or been turned off. Verify that the breaker is turned on. Also verify proper incoming power at input side of Transformer. If incoming power is present, verify 12 VAC at output of Transformer. If 12 VAC present replace temperature readout. If 12 VAC is not present, replace the Transformer.
A
amanda84Aug 21, 2025
What to do if the Wood Stone MOUNTAIN display lights but the readout is erratic?
- M
  Michael SandersAug 21, 2025
  If the display lights up but the readout is erratic or shows 'EEE' on your Wood Stone Oven, ensure that the Thermocouple connections on the readout module are correctly connected: Red to TC- (negative), yellow to TC+ (positive). Also, remove the Thermocouple wires from the display and create a jumper between TC+ and TC- on the display; the display should then show the ambient temperature. If it does not display the ambient temperature, replace the readout. If the readout displays the ambient temperature (when jumpered), replace the Thermocouple. If applicable, check the plug connection between the readout box and the Thermocouple. If this connection is defective, remove it and wire the Thermocouple directly.