Woodland MEMPHIS User Manual

W1
W19
Z31
W20
2. Wooden parts, if necessary, can be treated with natural wax or oil before the assembly of the bed.
Advice: We advise you not to treat the bed to sustain better environment for children (regulating humidity in the air). In addition it saves wax and oil costs and
offers advantage that it is easier to clean with tissues and cloth. Two further benefits: Untreated wood is easier for children to take a grip on handles and the
natural colour of the wood stays longer.
3. For the assembly of the bed you need the following tools: a ratchet with a size ten socket, a cross-end screwdriver (better yet a
cordless screwdriver with a changeable head and size ten ratchet attachment) and a hammer. Assistance is only necessary
when assembling the corner beams of the bed.
1. Please take a moment to see how everything fits together by using the diagram above. All the important building parts have
labers to help you see how they fit into the overview. Please note that there is a separate beam list as an additional assembly aid.
All beams are shown horizontally or vertically as they should be positioned and assembled together. The labels on the packages
Lets begin:
Assembly Instructions MEMPHIS Post. 506
B1-B16
Z30 Z30Z32
Z32
Z31 Z31
W13
W2
W14
W1
F2
F3
F1
W19
W20
W9
W8
Not all specifications are guaranteed.
© Copyrights by WOODLAND 1998
1.1.
Z30
Z30
Z31
Z31
W14
W1
W19
W8
2.2.
W1
Z31
Z31
Z32
Z32
Z30
Z30
W8
W19
W2
W14
W20
W9
W13
110mm flathead bolt
Start the assembly of the bed with the horizontal beams W1, W8, W14 and W19 (W = horizontal, S =
vertical).
CAUTION! All horizontal beams (W1, W2, W8, W9) are built in a way that the side with most
round indentations (= ), face inside and the surface with two round indentations face
underneath!
The labels as shown ´in , can be found on the end of each beam. Position the beams
on the floor so that you can still walk around the bed while it is in the building phase .
The surface of beam W13 with round indentations should face the inner side.
During the beam assembly install the flathead bolts from outside to inside. From the inside screw a
size 6 flange nut using a screwdriver with size 10 attachment. But do not over tighten bolts.
diagram1.1diagram1.1
1.1.
16mm 35mm
screws
110 mm
flathead bolt
flange nut M6
R
flange
nut M6

Woodland MEMPHIS Specifications

General

Brand	Woodland
Model	MEMPHIS
Category	Indoor Furnishing
Language	English

Summary

Assembly Preparation and Initial Steps

Understanding Assembly Overview

Review the diagram to understand how parts fit together and identify labeled components.

Wood Treatment Advice

Guidance on treating wooden parts with natural wax or oil for child safety and durability.

Tools and Assistance Needed

List of necessary tools for assembly and recommendation for assistance during corner beam assembly.

Initial Beam Assembly Caution

Important note on positioning round indentations and tightening flathead bolts correctly.

Mattress Support and Drawer Assembly

Corner and Middle Beam Assembly

Assemble corner beams and middle beam, ensuring round indentations face the middle.

Mattress Support Beam Placement

Position mattress support beams with notches facing upward and fix end beams vertically.

Drawer Assembly and Installation

Assemble drawers by attaching side boards to front/back boards and installing wheels.

Slatted Frame Installation

Place wooden pegs between slats and attach slats to beams, securing with screws.

Post-Assembly Tightening

Advise to re-tighten flathead bolts after approximately three weeks, avoiding over-tightening.