32 Assembly
MAN0845 (1/12/2011)
Figure 32
. Chain Shield Installation
Install Chain Shielding
Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped when any-
one comes within 300 feet (92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
1.
Install front and rear chain shields with hardware
shown.
Install Front Roller (Optional)
1.
Remove center belt shield from mower.
2.
Insert four carriage bolts (8) through top of deck
plate.
3.
Place roller bracket (1) over bolts; then install
flange lock nuts (9) on bolts and tighten.
4.
Place front roller (2), two bearings (4), spacer (3)
and two SAE flat washers (6) between roller
bracket as shown in Figure 33.
5.
Insert cap screw (5) through bracket and roller.
6.
Secure with flanged lock nut (7). Do not
overtighten, roller must spin freely.
Figure 33
. Front Roller Installation
1. Front chain shield plate
2. Rear corner chain shield plate
3. Left corner chain shield plate
4. Right rear chain shield plate
5. Left rear chain shield plate
6. 1/4 Chain - 3 link
7. 1/4 Chain - 4 link
8. Pin, 28 to 30 Chains
9. Pin, 7 to 9 Chains
10. Pin 40 to 42 Chains
11. 3/8 NC x 1 Carriage Bolt
12. 3/8 NC Flange Lock Nut
1.
Roller Bracket
2.
Roller
3.
Spacer
4.
Bearing
5.
1/2 NC x 9 HHCS
6.
1/2 SAE Flat Washer
7.
1/2 NC Flange Lock Nut
8.
3/8 NC Carriage Bolt
9.
3/8 NC Flange Lock Nut
To Next Page
Loading...
Need help?
General
