Woods RM990-3 - Page 35

Assembly 35
20944 (Rev. 2/3/2006)
Figure 30. P990-3 Tongue & H-Frame Installation
1. Tongue assembly
2. H-Frame
3. Carrier bearing housing
4. Drive shield
5. Attitude rod
6. 3/16 x 1" Cotter pin
7. 5/8 x 5-21/32" Clevis pin
8. 1/2 x 5-3/4" Clevis pin
9. 1/2" Heavy hex nut
10. 1/2" Heavy lock washer
11. 1/2 x 3-9/16" Pipe
12. 1/2 x 5-1/2" Bolt
13. 3/8 x 1" Bolt
14. 3/8" Lock washer
15. 5/8 x 2-1/4" Clevis pin
16. 5/8 x 3-1/2" Bolt
17. 5/8" Flat washer
18. .64 x 1 x 2" Sleeve
19. 5/8" Lock washer
20. 5/8" Hex nut
21. Parking jack
22. Front tether chain
23. Middle tether chain
24. Rear tether chain
25. Driveline