What to do if Woodward Switch shows Overcrank?
If your Woodward Switch is experiencing overcranking, it means the engine hasn't started after the maximum allowed autocrank attempts (AUTOCRANK_MAX_TRIES). The solution is to disable autocrank.
How to calibrate DSS-2 on a Woodward Switch?
If your Woodward Switch displays 'DSS-2 Uncalibrated', it means the PULSES_PER_REV parameter needs a non-zero value. Enter the number of teeth per engine revolution if you want to work in RPM, or enter 60 if you prefer working in Hz.
Why does Woodward DSS-2 show Channel 1 Overspeed?
Channel 1 Overspeed on your Woodward Switch indicates that the engine RPM has exceeded the Channel 1 speed setpoint, and CHNL_1_CONFIG.7 is set to 1. Resolve this by setting the appropriate condition.
Why does Woodward Switch show Channel 2 Overspeed?
Channel 2 Overspeed on your Woodward Switch means the engine RPM has surpassed the Channel 2 speed setpoint, and CHNL_2CONFIG.7 is set to 1. You should set the condition to resolve this.
General| Contact Form | SPDT |
|---|---|
| Mechanical Life | 1, 000, 000 cycles |
| Mounting | Panel Mount |
| Operating Temperature | -40°C to 85°C |
| Electrical Life | 100, 000 cycles |
To Next Page
