Supplied By www.heating spares.co Tel. 0161 620 6677
7 181 465 347 (05.01)
20
Rectifying faults
Error A8
A8 flashing.
No correct electrical connection
Check Action
1. B Power OFF the appliance.
B Check Wiring between Textdis-
play and TR 2:
– Terminal 3 on Textdisplay con-
nected to Terminal 3 TR 2?
– Terminal 4 ...Terminal 4
– Terminal F ...Terminal F?
yes: ↓2.
no: B Rewire correctly as specified in the installation
instructions.
B Turn ON the appliance.
After 90 sec.:
A8?
B Power OFF the appliance.
↓2.
2. B Check continuity on wiring to TR 2.
Is there continuity?
yes: ↓3.
no: B Replace or repair wiring and/or connections.
B Turn ON the appliance.
After 90 sec.:
A8?
B Power OFF the appliance.
↓3.
3. B Check resistance from connections
4 to F and 3 to 4.
Is resistance between XX and XX?
yes: B Replace TR 2.
no: ↓4.
4. The PCB control board is damaged. B Make a note of the altered service function set-
tings (see table 1 on page 7) in order to keep
the altered values.
B Power OFF the appliance.
B Disconnect the boiler electrical connection.
B Change PCB control board.
B Reconnect the boiler electrical connection.
B Turn ON the appliance.
B Restore service settings previously noted down.
To Next Page
Loading...
Need help?
General