10 / 21
Changing the LM GPIO name in WorkCAD
1-In order to change the name of the device, it is necessary to add it to a project,
therefore, press “+” icon in a device will be showed in “Network” tab. The device will
be inside “Project inspector” (Upper/left side).
2-Over the device name, press “left click” and a dropdown menu will be showed,
then, select “Rename” option.
3-Assign a new name.
Ones modified the name and IP address, it is advisable to reset the device in order
to store the data correctly.
To Next Page
Loading...
