WORKZONE TITANIUM TB-HT04-20 - Operation

AFTER SALES SUPPORT:
1300 777 137
service@actionspares.com.au
MODEL: TB-HT04-20 PRODUCT CODE: 61552 06/2019
AUS
8
6. OPERATION
WARNING: Always observe the pressure on the pressure gauge.
Never inflate object to a pressure greater than the maximum
pressure specified by the manufacturer of the object.
WARNING: Switch off the air pump immediately should any danger
arise.
WARNING: The metal parts on the adaptor and extension tube can
become very hot. Allow the parts to cool down before touching
these parts.
WARNING: The air pump should not continue operating for more
than 5 minutes. After 5 minutes, it must be switched off and allowed
to cool down for at least 10 minutes before restarting.
6.1 Insert and remove the battery pack (sold separately)
WARNING: Before inserting or removing the battery pack, make sure
the air pump is switched off.
a) To insert the battery pack, align the battery pack with the air pump's base and
slide the battery pack into the air pump, so that the battery pack is locked in
position.
b) To remove the battery pack, press the battery’s release button and pull the
battery pack off at the same time.
6.2 Fitting the air hose (Fig. 1)
a) Remove the battery pack from the air pump.
b) Insert the air hose connector (8) into the open
end of the air pump then tighten it by turning
clockwise.
c) To remove, turn the air hose connector (8)
anti-clockwise and remove the air hose.
Fig. 1