3. The air filter can be washed in warm soapy water. Do not use solvents.
Finish off with running warm water and then allow to completely dry.
4. If the filter is damaged or clogged with dirt etc, the filter should be
replaced.
5. Replace the cleaned or new filter into the housing of the compressor
(Fig AA), and press fit the air inlet filter cover back into the compressor
housing over the air filter.
WARNING: DO NOT operate the compressor without a lter in place.
NOTE: Replacement air filters are available for purchase by calling us on
1800 909 909 or emailing help@powertoolsupport.com
Y.
AA.
X.
Z.
W.
To Next Page
Loading...