EasyManuals Logo

Workzone 55903 User Manual

Workzone 55903
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
16
support@merotecusa.com
1866 902 9690
AFTER SALES SUPPORT
Cordless Reciprocating Saw · 20V Lithium-Ion Battery
Disposal
Dispose electrical appliances according to the regulations and requirements
of your local council. If electrical appliances are disposed in landfills or dumps,
hazardous substances may leak into the ground water and get into the food
chain, damaging your health and well-being.
Troubleshooting
Fault Possible cause Possible solution
Reciprocating
saw cannot
start.
Battery is not installed
properly.
Battery power is low.
Battery is damaged
Internal damage or wear.
Check the installation of the battery.
Recharge the battery.
Check the battery and replace if needed.
Have the reciprocating saw repaired by
an authorized service centre.
Reciprocating
saw can only
run slowly.
Battery power is low. Recharge the battery.
Reciprocating
saw cannot cut
efficiently
Blade wears out. Replace the blade with a new one if
needed.
Excessive noise
or rattling
Internal damage or wear. Have the reciprocating saw repaired
by an authorized service centre.
Overheating Blade is dull or damaged
Ventilation slots blocked
Change the blade if needed.
Clean the dust and dirt in the
ventilation vents.
Troubleshooting

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Workzone 55903 and is the answer not in the manual?

Workzone 55903 Specifications

General IconGeneral
BrandWorkzone
Model55903
CategorySaw
LanguageEnglish

Related product manuals