EasyManuals Logo

Workzone GT-MM-10 User Manual

Workzone GT-MM-10
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
CUSTOMER SERVICE
UK: 0800 / 328 6020
Info@globaltronicssupport.com
GT-MM-10, 09/13, E46106
Ireland: 00800 / 4467 5888
Battery instructions
Batteries must not be disposed of with household waste. Every consumer is
legally obligated to dispose of batteries properly at the designated collection
centres.
Never recharge non-rechargeable batteries! Explosion hazard!
Keep batteries away from children, do not throw into fire, short circuit or
dismantle.
If you suspect a battery to have been swallowed, seek immediate medical
attention.
Pay attention to correct polarity when inserting.
Clean battery and device contacts prior to insertion, if required. Immediately
remove depleted batteries from the device! Increased leakage hazard!
Do not expose batteries to any extreme conditions, e.g. on radiators or direct
sunlight! Increased leakage hazard!
Failure to comply with this could result in batteries being discharged beyond
their final charge voltage! Remove batteries immediately, in order to avoid
damage.
Avoid contact with skin, eyes and mucous membranes. When coming into
contact with battery acid, immediately rinse the affected areas with plenty of
clear water and immediately contact a physician.
Remove the batteries from the device, if it is not in use for a longer period of time.
If you suspect a battery has been swallowed, seek immediate medical assistance.
Additional safety instructions for pipe and electricity cable
detectors
Do not use the tool for detecting voltage in non-insulated/exposed cables.
Do not use the devices as a replacement for a voltmeter.
Be aware that the device may possibly not always detect all pipes and cables
correctly.
The following conditions can cause imprecise results:
–Weak battery
Thick walls with thin pipes or electricity cables
Very thick walls
Very deeply positioned electricity cables or pipes
Walls covered with metal
Very damp conditions
Shielded cable
Electrostatic charge
Always test the device prior to use by detecting a known pipe/known
electricity cable.
In case of doubt, always ask a qualified builder.
CAUTION:
The Multi-Sensor is designed for private household use.
It is unsuitable for use in workshops, jewellery shops, etc.
Multi Sensor UK WORKZONE E46106.book Seite 4 Montag, 22. April 2013 1:20 13

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Workzone GT-MM-10 and is the answer not in the manual?

Workzone GT-MM-10 Specifications

General IconGeneral
BrandWorkzone
ModelGT-MM-10
CategoryAccessories
LanguageEnglish