Workzone MMA-140 - Workpiece and Surface Safety; Ventilation and Electrical Safety

10
140AMP Inverter Welder
MMA-140 53528 10/2016
01904 727506 www.coreservice.co.uk
GB
012475150
IRE
AFTER SALES SUPPORT
MMA-140 76597 09/2017
Safety Instructions
Workpiece
The workpiece will remain at a high temperature for a relatively long
period. Do not touch the weld or the workpiece unless you are wearing
welding gloves. Always use pliers or tongs.
Never touch the welded material with bare hands until it has been
allowed to cool.
Welding surfaces
• Do not weld on containers or pipes that hold, or have held,
• Do not weld coated, painted or varnished surfaces as the
Ventilate the work area
Arc welding emits fumes which can be dangerous. Make sure that
the work area is well ventilated.
Avoid electrical contact
Use adequate electrical insulation with regard to the electrode, the
workpiece and any accessible earthed metal parts in the vicinity.
Avoid direct contact with the welding circuit. The no load voltage
between the earth clamp and the electrode can be dangerous
under certain circumstances.
For additional protection from electric shock
It is recommended that this tool be used in conjunction with
a residual current device (RCD) with a rated residual current of