27
27
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
MODEL No.:
info.aldi@positecgroup.com
BL20AL • 8213 • 06/2019
For setting the torque position, first select a low setting on the
Torque adjustment ring / setting (2) and align the selected number
with the triangular indicator on the top of the drill / driver.
Slowly increase the torque setting to the desired level. It is
suggested to test the setting on scrap material first.
5. HOW DO I USE THE 2 GEARS ON THE DRILL?
To select LOW speed (mark is 1) (e.g. low speed, high torque
setting), push the gear selector forward, towards the chuck. The
number “1” will be displayed.
To select the HIGH speed (mark is 2) (e.g. high speed, low torque
setting), push the gear selector backwards. The number “2” will be
displayed.
NOTE: The gears cannot be changed if the Forward / Reverse touch
pad is depressed.
6. WHY IS THE BATTERY PACK WARMING WHEN CHARGING?
This is a result of the stepping down of the chemical reactions inside
the batteries during the charging process. Thiss is normal.
7. WHAT DO I DO IF MY FAULT IS NOT DIAGNOSED IN THIS
SECTION?
Contact Customer Service for further direction on how to proceed.
For further inquiries or issues associated with your tool, call our
Customer Service on 1300 889 028 or email us at
info.aldi@positecgroup.com
To Next Page
Loading...
Need help?
General
