Workzone WZTS 1701 - Page 21

21
d
1300 922 271
service.australia@einhell.comAFTER SALES SUPPORT
WZTS 1701
09/2013
5
Before starting the equipment
• Before you connect the equipment to the power supply make sure
that the data on the rating plate are identical to the supply voltage.
• Only ever connect the equipment to a properly installed shock-proof
socket which is protected by a 10A fuse as a minimum.
• Always pull out the power plug before making adjustments to the
equipment.
• Unpack the table saw and check it for damage which may have
occurred in transit.
• Make sure the machine stands securely, i.e. bolt it to a workbench or
solid base.
• All covers and safety devices have to be properly fitted before the
equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed before, watch out
for foreign bodies such as nails or screws, etc.
• Before you actuate the On/Off switch, make sure that the saw blade is
correctly fitted and that the equipment‘s moving parts run smoothly.
Assembly
Important! Disconnect the power plug before carrying out any
maintenance, resetting or assembly work on the circular saw!
You will need the following tools for the assembly work:
• Open-ended spanner or ring spanner size 10, size 24
• Allen key 4 mm
• Crosstip screwdriver PH2
WZTS_1701_AUS_SPK7.indb 21 06.05.13 11:17