World Dryer SLIMdri L-Series

Questions and Answers

S
Shannon FitzgeraldJul 27, 2025
Why won't my World Dryer SLIMdri L Dryer start?
- D
  dcoleJul 28, 2025
  If your World Dryer isn't starting, several factors could be at play. First, check the sensor lens for any obstructions. Next, ensure the unit is receiving power; if the LED light is off, inspect the electrical connections. If the LED is on, listen for a 'Click' from the PCB relay when placing your hands under the sensor; no click indicates the PCB needs replacement. Alternatively, the motor brushes may need replacing. Also, verify that all incoming power supply connections are secure.
J
Justin MiddletonAug 3, 2025
Why does my World Dryer Dryer start by itself?
- B
  Billy LeeAug 3, 2025
  If your World Dryer Dryer starts on its own, it could be due to a few reasons. First, ensure the dryer is not too close to any counters or objects; relocate it according to the installation instructions, maintaining a minimum of 18 inches above any reflective surface and at least 24 inches from another hand dryer. Next, confirm the dryer base is securely grounded to eliminate electrical noise. Also, make sure the dryer is on a dedicated circuit. Check if any nearby infrared actuated devices are triggering the dryer. If none of these resolves the issue, the circuit board (PCB) may be faulty and require replacement.
J
Jerry DennisAug 9, 2025
How to fix cold air from World Dryer SLIMdri L Dryer?
- E
  esparzakristenAug 9, 2025
  If the air from your World Dryer Dryer is too cold, first check if the heater control switch is in the 'OFF' position and re-position it to 'ON'. If the switch is already 'ON', place your hands under the sensor and listen for a 'Click' from the PCB relay. If there is no 'Click', the PCB may be faulty and needs replacement. If you hear the 'Click' but the air remains cold, the heating element itself may be faulty and require replacement.
J
Jennifer AcostaAug 15, 2025
What to do if World Dryer SLIMdri L stops after 30 seconds?
- P
  Phillip SmithAug 15, 2025
  If your World Dryer Dryer runs briefly and then refuses to restart, the issue might be a sensor obstruction or damage. Inspect the sensor lens for any foreign material or dirt. Clean the lens with a soft, damp cloth and a mild cleaning agent. If the sensor lens is scratched or damaged, consider replacing the sensor.
M
Morgan FoleyAug 21, 2025
How to reduce noise from World Dryer SLIMdri L?
- D
  David GuzmanAug 21, 2025
  Excessive noise or vibration in your World Dryer Dryer can stem from a couple of sources. Ensure the dryer is securely mounted to the wall and that the motor mounts are tight. Also, inspect the fan housing and dryer outlet for any foreign material and remove it.