To Next PageTo Next PageWhy my Worx Nitro WG325E Cordless Saw fails to operate?
If your Worx Nitro Cordless Saw fails to operate, there are a couple of potential reasons. The most common one is that the battery is out of charge, so try charging the battery pack. Alternatively, the fuse might be faulty, in which case you should replace it.
Why chain/chain bar over-heats on Worx Nitro WG325E Cordless Saw?
If the chain or chain bar of your Worx Nitro Cordless Saw is overheating, it could be due to a couple of reasons. First, the chain might be over tensioned, so try adjusting the chain tension. Alternatively, the chain could be dull, in which case you should sharpen or replace the chain.
What to do if my Worx Nitro WG325E operates intermittently?
If your Worx Nitro Cordless Saw operates intermittently, it could be due to several factors. One possibility is overheating; in this case, place the machine in a cool, ventilated place to cool it down. Another reason could be applying too much pressure while cutting, so try applying relatively less pressure. Finally, there may be a loose connection, defective internal wiring, or a defective on/off switch, in any of these cases you should contact service agent.
General| Brand | Worx Nitro |
|---|---|
| Model | WG325E Series |
| Category | Cordless Saw |
| Language | English |
