Programming guide
Control Panel and menu
Programming
After you have successfully installed the Landroid
®
L, it is now ready to be programmed according to your schedule. To program your Landroid
®
L, simply follow the step by step guide below.
Menu overview
OK
Confirms any setting.
Note: Make sure you confirm your
selection within 30 secs or the
display will return to previous menu.
RETURN
Back to proceeding menu
START
Shortcut key to start mowing.
Select down
Select up
STOP
Opens the protective screen to
access the keyboard.
To stop the Landroid
®
L during
normal operation and charging.
HOMEPAGE
Display the state of your setting
HOME
Sends the Landroid
®
L to its
charging base during operation
POWER ON/OFF
turns the Landroid
®
L
ON and OFF
HOMEPAGE
Language
Time Format
Date Format
Set Date & Time
Rain Start Delay
Auto Work Time
Customize Work Time
Customize Work Area
Enable Boundary Cut
Change PIN Code
Alarm Level
General Setting
Working Time
Security
Start
To quick start your Landroid
®
L, first Open the keypad window by pressing the large red button , then Press ON/OFF button , input the default PIN 0000, and Press to
start and close the keypad window. Press
and close the keypad window , this will send Landroid
®
L back to the charging station and mow the lawn near the boundary wire.
The Landroid
®
L will work continuously until it is out of battery and then it will return to the charging base. Once charging is complete, the Landroid
®
L will automatically resume
mowing or if it has finished mowing it will stay in the charging base.
The factory default setting is 1500m
2
(refer to the Auto Mowing Time Schedule), if the time is not in the schedule, press to start and close the keypad window.
If you want to change the working time and other settings, please follow the steps below:
Setting
Press OK to enter the submenu.
Use the
keys to select General setting, Working time or Security. Then press OK.
1. General setting ( )
Always close the keypad window
after programming.
Your Landroid
®
L will not move
with it open.
EN
WG792E
To Next Page
Need help?
General
