Worx WA3739 - Charging Procedure

Battery Charger EN
11
SYMBOLS CHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices.
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for
the tool to cool down before re-charging to
achieve the full charge.
2. BEFORE USING YOUR CORDLESS
TOOL
Your battery pack is UNCHARGED and you
must charge once before use. When you
charge the new battery or one which has not
been used for long periods of time, it may
not reach full charge until after you have
discharged it fully in use and recharge it
several times.
3. HOW TO CHARGE YOUR BATTERY
PACK (See Fig. A, B)
1 - Connect the battery charger to the power
supply and the light (1) will turn green.
2 - Push battery into charger base (2) until a
“click” sound is heard.
Red light: Battery is charging
Green light: Battery is fully charged
3 - When charging is completed, unplug the
charger and remove the battery pack.
NOTE: This charger is designed to detect
some problems that can arise with battery
pack.
Read the operator’s manual
Warning
For indoor use only
Double insulation
Fuse
T 2 A long time lag fuse with rated
current of 2 A
Positive terminal
Negative terminal