Worx WA3739 - Maintenance

Battery Charger EN
13
MAINTENANCE
TROUBLESHOOTING GUIDE – Problems and Solutions
Problem Possible Cause Solution
Green ON, but
battery does not
charge when
inserted into the
charger
Battery is not inserted into the
charger properly
Slide the battery into the charger
properly
Battery contacts are not
connecting properly
Remove any debris from the battery
contacts (try inserting and removing
the battery several times) or replace
the battery
Defective Battery Replace the battery
No light
(Neither the red
or green light
illuminates)
Battery charger plug is not
properly connected to power
supply
Insert the main plug of battery charger
fully into the electrical outlet
Electrical outlet, battery
charger cable, or battery
charger is defective
Check the voltage; have the battery
charger checked by our service agent
or a similarly qualified person
1. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER. WHY?
1) Check if the charger and the battery pack are specifically designed for working together.
2. REASONS FOR DIFFERENT CHARGING TIMES
The charging time can be affected by many reasons which are not defects in your product.
1) If the battery pack is only partly discharged it may be re-charged in less than 3 hours.
2) If the battery pack and ambient temperature are very cold then re-charging may take more
hours.
3) If the battery pack is very hot you must remove your battery pack from the charger and allow
your battery pack to cool first to ambient temperature and then recharging can be started.
NOTE: The charging time can be affected by many reasons which do not indicate defects in your
product.
Remove the plug from the electrical socket before carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance. Never use water or chemical
cleaners to clean your tool. Wipe clean with a dry cloth. Always store your tool in a dry place.