Ii' WARNING: This product can expose
LDyou
to
chemicals including lead,
phthalate
or
bisphenol A which are known
to
the State
of
California
to
cause cancer, birth
defects
or
other reproductive harm. Wash
your
hands after use. For
more
information
go
to
www.P65Warnings.ca .gov.
INFORMATION FOR RADIATED
EMISSION
This device complies
with
Canadian
ICES-001.
This device complies
with
Part
15
of
the
FCC
Rules.
Operation is subject
to
the
following
two
conditions:
1)
This device may
not
cause harmful
interference, and
2)
This device must accept any interference
received, including interference
that
may
cause undesired operation.
Ii' WARNING: Changes
or
modifications
LDto
this
unit
not expressly approved
by
the
party responsible
for
compliance could
void the user's authority
to
operate the
equipment.
NOTE:
This
equipment
has been tested and
found
to
comply
with
the
limits
for
a Class B
digital device, pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed
to
provide
reasonable protection against harmful
interference
in
a residential installation. This
equipment
generates, uses and can radiate
radio frequency energy
and,
if
not
installed
and used in accordance
with
the instructions,
may
cause harmful interference to radio
communications.
However, there is no guarantee that
interference
will
not
occur in a particular
installation. If
this
equipment
does cause
harmful interference
to
radio
or
television
reception, which can
be
determined by
turning the
equipment
off
and on, the user is
encouraged
to
try
to correct the interference
by one
or
more
of
the
following
measures:
• Reorient
or
relocate the receiving antenna.
• Increase the separation between the
equipment
and receiver.
Connect
the
equipment into
an
outlet
on
a circuit different
from
that
to
which
the
receiver is connected.
• Consult the dealer
or
an experienced radio/
TV technician
for
help.
CHARGING
PROCEDURE
riITlI1
NOTE: Before using the
tool,
read the
I1b!dIJ
instruction
book
carefully.
CHARGING INSTRUCTIONS
1.
CHARGING YOUR BATTERY PACK
Ii' WARNING: The charger and battery
LD
pack are specifically designed
to
work
together
so
do
not
attempt
to
use any
other
devices. Never insert
or
allow
metallic objects
into
your
charger
or
battery pack connections
because an
electrical failure and hazard
will
occur.
2.
BEFORE
USING
YOUR CORDLESS
TOOL
Your battery pack is UNCHARGED and you
must
charge once before use.
3.
HOW
TO
CHARGE YOUR BATTERY
CHARGING PROCEDURE
1)
Plug
the
charger
into
an
appropriate
outlet.
2) Slide the battery pack
into
the
charger, The
__
_
LIGHT
(1)
will
become green and flash
to
&
show
charging has started.
3)
After
charging
approx
5 hours,
the
light
will
stay green
without
flashing, which
means
the
battery is full, and charging is
completed.
Ii' WARNING:
LD
When
battery
charge
runs
out
after
continuous
use
or
exposure
to
direct
sunlight
or
heat.
allow
time
for
the
battery
to
cool
down
before
re-charging
to
achieve
the
full
charge.
CHARGING INDICATOR
This charger is designed
to
detect
some
problems
that
can arise
with
battery packs.
Indicator lights indicate
problems
(see table
below).
If
this occurs, insert a
new
battery
pack
to
determine
if
the
charger is OK. If
the
new
battery charges correctly, then the
original pack is defective and should be
returned
to
a service center
or
recycling
service center.
If
the
new
battery pack
displays
the
same
problem
as
the
original
Battery
Pack,
have
the
charger tested at
an
authorized service center.
Battery
Charger
EN
To Next Page
Loading...
