Worx WA3742 - Troubleshooting; To Remove or Install Battery Pack; Reasons for Different Charging Times

4. TO REMOVE OR INSTALL BATTERY
PACK
Depress the Battery Pack Release Button to
remove the Battery Pack from your tool. After
recharging, insert the battery pack into the
battery port. A simple push and slight pres-
sure
will be sufficient.
PROBLEM SOLU,.ION
I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER.
WHY?
a) Check if the charger and the battery pack
are
specifically designed for working
together.
b) The
battery pack can be inserted into
the charger only in one direction. Turn
the
battery pack around until it can be
inserted
into the slot, the indicator light
should be green and flash when the
battery pack is charging.
REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many
reasons which are not defects in your product.
a) Ifthe battery pack is only partly
discharged it may be re-charged in less
than rated charging time. (approx. 5
hours).
b)
If the battery pack and ambient
temperature are very cold! hot, it may
take longer to re-charge. Please find an
appropriate environment with proper air
temperature to start charging.
c) If the battery pack is very hot, remove
battery pack from the charger and
allow battery pack to cool to ambient
temperature and then recharging can be
started.
MAIN,.AIN ,.OOLS WI,.a
CARE
Remove the plug from the socket before
carrying out any adjustment. servicing
or maintenance.
Your tool requires no additional lubrication
or maintenance. Never use water or chemical
cleaners
to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place.
If
the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
Ballery Charger EN
7