Battery Charger  EN
6
Green 
Flashing
Charging
Green ON Fully Charged
Red Flashing
 The  temperature 
of battery pack 
is less than 32°F 
(0°C) or more than 
113°F (45°C).
Red ON Defective Battery 
NOTE: 
1.  The charger will not automatically switch 
off when the battery is full charged. Do not 
leave your battery on charge continuously. 
This may damage the battery cells.
  Do not overcharge any batteries.
 
WARNING: After long usage the 
battery will become hot. Let the hot 
battery cool down for at least 0.5 hour 
before recharging.
2.  Do not charge a battery when it too hot or 
the air temperature is blew 4
o
C.
3.  In a warm environment or after heavy use, 
the battery pack may become too hot to 
permit charging. Allow time for the battery 
to cool down before recharging.
  When the battery is charged for the first 
time and after prolonged storage, the 
battery will only accept approximately 
60% charge. However, after several charge 
and discharge cycles the battery will 
accept a 100% charge.
4.  It must be charged for 12 hours before 
using the first time!
5.  When charging is completed, unplug the 
charging plug form the wall socket.
 
WARNING: Shock hazard. Don’t 
allow any liquid to get inside 
charger. Electric shock may be the result.
CAUTION: Never attempt to open the battery 
pack for any reason. If the plastic housing of 
the battery pack breaks or cracks, return to a 
service center for recycling.
STORAGE RECOMMENDATIONS
1.  The best storage place is one that is cool 
and dry away from direct sunlight and 
excess heat or cold. 
2. 
If the battery pack will not be used for 
a long time, it is best to make sure it is 
properly stored. Make sure it is half or 
fully charged before storing. The battery 
should be stored in an area that maintains 
a temperature of approximately 65°F and 
75°F (18°- 24°C). Long term exposures to 
hot temperatures are hazardous to the 
battery packs life. Additionally, the battery 
pack should be charged at least once a year.
MAINTENANCE
ROBLEMS AND SOLUTIONS
1. I CANNOT FIT THE BATTERY INTO THE 
BATTERY CHARGER. WHY?
1)  Check if the charger and the battery pack 
are specifically designed for working 
together.
2. REASONS FOR DIFFERENT CHARGING 
TIMES
The charging time can be affected by many 
reasons which are not defects in your product. 
1)  If the battery pack is only partly discharged 
it may be re-charged in less than 5 hours.
2)  If the battery pack and ambient 
temperature are very cold then re-charging 
may take more hours. 
3)  If the battery pack is very hot you must 
remove your battery pack from the charger 
and allow your battery pack to cool first to 
ambient temperature and then recharging 
can be started.
NOTE: The charging time can be affected by 
many reasons which do not indicate defects in 
your product.
Remove the plug from the electrical 
socket before carrying out any 
adjustment, servicing or maintenance.
Your tool requires no additional lubrication 
or maintenance. Never use water or chemical 
cleaners to clean your tool. Wipe clean with a 
dry cloth. Always store your tool in a dry place.