Why is my Worx Trimmer not working?
If your Worx Trimmer isn't working, it could be due to a discharged battery. Try charging the battery. Alternatively, the battery might be too hot or cold; allow it to reach a normal temperature. In some cases, the motor may be broken, requiring you to check, repair, or replace it. Damaged internal wiring could also be the cause; inspect and repair the wiring.
What to do if the line is broken or grass is entangled in my Worx WG157E?
If the Worx Trimmer's cutting line breaks, replace it. If the battery isn't fully charged, recharge it. If the motor is broken or the speed is too low, contact a service agent. Also, make sure to remove any grass entangled around the cutting head.
How to fix Worx WG157E when the cutting line is not feeding?
If the cutting line of your Worx Trimmer is not wound well, manually feed the line, or remove the spool and rewind the line. If the line is tangled or used up, replace it with a new line spool.
What to do if my Worx WG157E does not cut?
If your Worx Trimmer isn't cutting, the line might be broken, so replace it. Also, ensure the battery is fully charged. A broken motor (resulting in low speed) can also be the reason; check, repair, or replace it. Finally, check for and remove any grass entangled around the cutting head.
How to fix excessive vibrations or noise in Worx WG157E Trimmer?
Excessive vibrations or noise in your Worx Trimmer could indicate a defective machine. Inspect and repair the machine. Alternatively, the line spool might not be wound well; rewind the line properly.
What to do if auto feed does not work on Worx Trimmer?
If the auto feed on your Worx Trimmer isn't working, it could be because the cutting line is not wound well; rewind it properly. Another reason might be that the line is tangled; untangle it. If the line is used up, replace it.
Why is my Worx WG157E Trimmer not turning on?
If the motor of your Worx Trimmer is broken or the On/Off switch is defective, contact a service agent. If the battery is not fully charged, recharge it.
What to do if my Worx WG157E Trimmer charger is not working?
If the plug of your Worx Trimmer battery charger is not plugged in properly, insert it fully into the socket outlet. Check the mains voltage. If the socket outlet, mains cable, or battery charger is defective, have the battery charger checked by an authorized after-sales service agent.
Why does my Worx WG157E run intermittently?
If your Worx Trimmer runs intermittently, it could be due to a broken motor, so check, repair, or replace it. Ensure the battery is fully charged. Another potential cause is a defective On/Off switch, which you should inspect and replace if necessary.
Why is the cutting time per battery charge too low on my Worx WG157E Trimmer?
If the cutting time per battery charge is too low on your Worx Trimmer, it might be because the battery hasn't been used for a long period or has only been charged for a short time. Use the battery regularly and charge it fully. Also, cutting grass that is too high can reduce battery life, so cut grass when it is at a lower height. The battery itself could also be defective, requiring replacement.
Covers machine familiarization, pre-use inspection, and safe operation procedures including protective gear.
Do not dismantle, short-circuit, expose to heat, fire, or shock. Keep terminals clean and dry.
Instructions for safety switch, trimming, edging, line feeding, and cap removal.
A guide to common problems, their possible causes, and corrective actions.
To Next Page
General
