OPERATING INSTRUCTIONS
WARNING! Do not use the product without
fitting the guard.
1. ASSEMBLY OF THE GUARD
(See Fig. A)
Insert the guard into the slot as illustrated in Fig A, and
use two screws to fix the guard securely.
2. FITTING THE SHOVEL (See Fig. B-C) (WG208E)
Place the shovel until into place, tighten the screws.
You can fit the shovel on both sides (Left hand or Right
hand).
3. MAINS SUPPLY CABLE STRAIN RELIEF (See
Fig. D)
For strain relief of the cable, form a loop of the end of
the extension cable and bring this through the opening
at the handle and suspend in the tension relief at the
handle.
4. STARTING AND STOPPING (See Fig. E)
BEFORE STARTING YOUR HEDGE TRIMMER
Remove blade sheath (7) as illustrated in Fig F.
B
C
A
D