Worx WG291 Instruction Manual

13
Cordless Hedge Trimmer EN
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY & OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the Safety Guard See Fig. A
Assembling the Front Handle
Note: Handle screws should
be facing the protective shield.
If the handle is assembled
incorrectly, the tool will not
power on.
See Fig.
B1,B2, B3
Installing and Removing the
battery park
See Fig. C1,
C2
Checking the battery charge
condition
See Fig. D1
Charging the battery pack
More details can be found in
WA3859’s manual
See Fig. D2
OPERATION
Starting and stopping
See Fig. E1,
E2, E3
HOW TO USE YOUR HEDGE
TRIMMER
Top cutting See Fig. F1
Side cutting
See Fig. F2,
F3
Lubricating the cutting blade See Fig. G
To store your hedge trimmer See Fig. H
HOW TO USE YOUR HEDGE TRIMMER
(See Fig. F1, F2, F3)
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levers (5 & 2)
before attempting to clear jammed debris from
the cutting blades.
Do not attempt to cut stems that are too thick
for the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. F1). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
SIDE CUTTING
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig. F2,
F3), tapering the hedge inward at the top. This
shape will expose more of the hedge, resulting
in a more uniformed growth.
CLEANING
REMOVE THE BATTERY PACK (3). Use a soft
brush to remove debris from all air intakes and
cutting blade.
Wipe the surface with a dry cloth.
WARNING:
Never use water for cleaning your
trimmer. Do not clean with chemicals,
including petrol, or solvents as this may
damage your trimmer.
TO STORE YOUR HEDGE TRIMMER
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
Ensure the blade sheath is fitted before
storage.
Store in a dry place where your trimmer can
be protected from damage.
MAINTENANCE
Remove battery from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.

Worx WG291 Specifications

General

Brand	Worx
Model	WG291
Category	Trimmer
Language	English