Worx WG505E Safety And Operating Manual Original Instructions

8
All-in-One blower/vac/mulcher WG505E
g) Before use, check the supply
and extension cord for signs
of damage or aging. If the
cord becomes damaged
during use, disconnect
the cord from the supply
immediately. DO NOT
TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Do not use the machine if the
cord is damaged or worn.
h) Keep extension cords away
from moving hazardous parts
to avoid damages to the cords
which can lead to contact with
live parts.
i) If an extension cord is used
make sure it is for outdoor
use and marked as such.
The recommended size of
extension cord is not lighter
than 1mm
2
.
3) Operation
a) Before starting the machine,
make certain that the feeding
chamber is empty.
b) Keep your face and body away
from the feed intake opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute, or
near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand at a
higher level than the base of
the machine when feeding
material into it.
e) Always stand clear of
the discharge zone when
operating this machine.
f) When feeding material into
the machine be extremely
careful that pieces of metal,
rocks, bottles, cans or other
foreign objects are not
included.
g) If the cutting mechanism
strikes any foreign objects or
if the machine should start
making any unusual noise
or vibration, immediately
shut off the power source
and allow the machine to
stop. Disconnect the machine
from the supply and take
the following steps before
restarting and operating the
machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii) check for and tighten any
loose parts.
h) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback of
material through the intake
opening.
i) If the machine becomes
clogged, shut-off the power
source and disconnect the
machine from supply before
cleaning debris.
j) Never operate the machine
with defective guards or
shields, or without safety
devices, for example debris
collector in place.
k) Keep the power source

Worx WG505E Specifications

General

Brand	Worx
Model	WG505E
Category	Blower
Language	English