Cordless Li-Ion Blower/Sweeper EN
54
TECHNICAL DATA
Type WG568E WG568E.9 (5-designation of machinery, representative of Cordless
Blower Vacuum)
WG568E WG568E.9
Voltage 40V Max* Lithium
No load speed 0-12000/min
Blow speed 230km/h Max
Air capacity 4m
3
/min Max
Charging time 1hr approx.
Machine weight 2.7kg 1.9kg
* Voltage measured without workload. Initial battery voltage reaches maximum of 40 volts.
Nominal voltage is 36 volts.
NOISE/VIBRATION INFORMATION
A weighted sound pressure L
pA
:79dB(A)
A weighted sound power L
wA.d
:93dB(A)
K
pA
3dB(A)
Wear ear protection when sound pressure is over
80dB(A)
Typical weighted vibration <2.5m/s
2
K=1.5m/s
2
WARNING! The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials is cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately
managed.
WARNING! To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Help to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions and keep well lubricated (where
To Next Page
Loading...
