3-speed Workshop Blower EN
6
d) Operate the machine in
a recommended position
and only on a firm, level
surface.
e) Do not operate the
machine on a paved or
gravel surface where
ejected material could
cause injury.
f) Before using, always
visually inspect to see,
that the fasteners are
secure, the housing is
undamaged and that
guards and screens are
in place. Replace worn or
damaged components in
sets to preserve balance.
Replace damaged or
unreadable labels.
3)Operation
a) Before starting the
machine, make certain
that the feeding chamber
is empty.
b) Keep your face and body
away from the feed intake
opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute,
or near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand
at a higher level than the
base of the machine when
feeding material into it.
e) Always stand clear of
the discharge zone when
operating this machine.
f) If the machine should
start making any unusual
noise or vibration,
immediately shut off the
power source and allow
the machine to stop.
Remove the battery pack
from the machine and
take the following steps
before restarting and
operating the machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii)check for and tighten any
loose parts.
g) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback
of material through the
intake opening.
h) If the machine becomes
clogged, shut-off the
power source and remove
the battery pack from the
machine before cleaning
debris.
To Next Page
Loading...
Need help?
General
