26
PH3 1 1
PH2 3 3
PH1 2 2
USB charging cable 1 1
60mm magnetic bits
holder
1 1
50mm impact rated drill
bits(PH2)
1 /
50mm PH2 / 1
50mm SL4 / 1
φ3mm twist drill / 1
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Usage
The electric tool can be used for fastening or removing
screws on wood, metal, plastic and other materials.
ACTION FIGURE
BEFORE OPERATION
A) Charging the Battery
NOTE:
Prior to initial use, the battery must
be charged 5 hours to fully utilize the
battery capacity.
B) Charging
Connect the USB-C cable to the
charger, and plug the charger into the
matching socket. During the charging
process, the green light will flash; after
the charging is completed, three cells
of the green light will always be on.
Unplug the charger and disconnect the
charging cable from the machine. The
machine is ready to be used.
Important notice:
During the charging process, the
charger and the body surface will feel
hot, which is a normal phenomenon.
See Fig A
ASSEMBLY AND ADJUSTMENT
Inserting and Removing Bits See Fig B
Forward / reverse operation
See Fig C,D
To Next Page
Loading...
