22
objects and protect against dirt and humidity. Store
in a dry and frost-free place.
15. When charging batteries, ensure that the battery
charger is in a well-ventilated area and away from
inflammable materials. Batteries can get hot during
charging. Do not overcharge any batteries. Ensure
that batteries and chargers are not left unsupervised
during charging.
16. Do not recharge non-rechargeable batteries, as they
can overheat and break.
17. Longer life and better performance can be
obtained if the battery pack is charged when the
air temperature is between 18
o
C and 24
o
C. Do not
charge the battery pack in air temperatures below
4.5
o
C, or above 40.5
o
C. This is important as it can
prevent serious damage to the battery pack.
SAFETY WARNINGS FOR BATTERY CELLS INSIDE
THE TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal. Do
not store power tool haphazardly in a box or
drawer where charging terminal may short-
circuit each other or be short-circuited by
conductive materials. When power tool is not
in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small
metal objects, that can make a connection from one
charging terminal to another.
c) Do not expose power tool to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject power tool to mechanical shock.
e) In the event of battery leaking, do not allow
the liquid to come into contact with the skin
or eyes. If contact has been made, wash the
affected area with copious amounts of water
and seek medical advice.
f) Seek medical advice immediately if a cell has
been swallowed.
g) Keep power tool clean and dry.
h) Wipe the charging terminals with a clean dry
cloth if they become dirty.
i) Power tool needs to be charged before use.
Always refer to this instruction and use the
correct charging procedure.
j) Do not maintain power tool on charge when
not in use.
k) After extended periods of storage, it may
be necessary to charge and discharge the
power tool several times to obtain maximum
performance.
l) Battery gives its best performance when it is
operated at normal room temperature (20°C ±
5°C).
m) When disposing of cells, keep cells of
different electrochemical systems separate
from each other.
n) Recharge only with the charger specified by
WORX. Do not use any charger other than
that specifically provided for use with the
equipment. A charger that is suitable for one type
of battery may create a risk of fire when used with
another battery.
o) Keep power tool out of the reach of children.
p) Retain the original product literature for future
reference.
q) Dispose of properly.
To Next Page
Loading...
