24
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ACTION FIGURE
Before operation
Charging the Battery
NOTE:
1. Maximize Battery Performance Prior to
initial use, the battery must be charged 5
hours to fully utilize the battery capacity.
2. When the battery is full charged, the
light turns green.
See Fig. A
Assembly and adjustment
Selecting the Proper Bit See Fig. B
Inserting and Removing bits See Fig. C
Forward/reverse/lock
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it is stopped!
See Fig. D1,
D2, D3
Adjust the Extended Shaft Position See Fig. E, F
Operation
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed because
excess heat will be produced internally.
See Fig. G
LED Light Indicator See Fig. G
MAINTENANCE
Your power tool requires no additional lubrication or
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power tool.
To Next Page
Loading...
