14
automatically when the cover is opened. (See Fig. D).
NOTE:
1. Only 25mm hex shank Bits are compatible with the
screwdriver.
2. If the Cover is not open fully, the Bit Cartridge will
get stuck when taking it out from the tool. Pull the
cover all the way back.
3. The Cover may not fully close if the Bit Cartridge
is not properly aligned inside. Make sure the Bit
Cartridge has clicked into place when selecting the
desired Bit to use. If the cover cannot properly close,
just turn the Cartridge clockwise or counter-clockwise
a little Bit and try again.
3. SWITCH LOCK
The On/off Switch can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
the screwdriver is not in use. To lock the On/off Switch,
place the Forward/Reverse Rotation Control in the center
position.
4. FORWARD/REVERSE ROTATION CONTROL (See
Fig. E1, E2)
For drilling and screw driving in a clockwise rotation,
move the switch marked “
” lever to the left. For
reverse rotation, move the switch marked “
” lever to
the right.
WARNING: Never change the direction of
rotation when the Chuck is rotating, wait
until it has stopped!
5. FULLY AUTOMATIC SPINDLE LOCKING (AUTO-
LOCK) (See Fig. F)
The screwdriver Chuck (6) is locked when the On/Off
Switch (4) is not pressed.
This allows the driver to be used manually when needed.
IMPORTANT:
When using as a manual tool, do not press the On/Off
Switch (4). Otherwise the screwdriver will be damaged.
6. USING THE LED LIGHT
To turn on the light simply press the On/Off Switch. When
you release the On/Off Switch, the light will go off.
LED light increases visibility and is great for dark or
enclosed areas.
7. PROTECTION AGAINST DEEP DISCHARGING
The Li-Ion battery is protected against deep discharging
by the “Discharging Protection System”. When the battery
is empty, the machine is switched off by means of a
protective circuit. The Chuck longer rotates. When this
occurs, recharge the battery.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
To Next Page
Loading...
Need help?
General
