11
WX279 WX279.X
Lithium-Ion Brushless
Impact Wrench
Using The LED Light
Before operation, the LED light
will be activated when the On/Off
switch is slightly depressed, and will
automatically turn off 20 seconds
after the On/Off switch is released.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 3
seconds and turn off, the system
will automatically cut off power to
the tool to extend battery life. The
tool will automatically stop during
operation if the tool and/or battery
are placed under one of the following
conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage: The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
WARNING:
To turn on the light, press the
On/Off switch and make sure the
Forward/Reverse Rotation Control is
on right/left position.
See Fig. F
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in
one direction. Turn the battery around until it can
be inserted into the slot, the red LED Light should
turn on when the battery is charging.
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having
not used a Battery Pack for a prolonged time will
reduce the Battery Pack working time. This can
be corrected after several charge and discharge
operations by charging & working with your drill.
Heavy working conditions such as large screws
into hard wood will use up the Battery Pack energy
faster than lighter working conditions. Do not
re-charge your Battery Pack below 0
o
C and above
30
o
C as this will affect performance.
MAINTENANCE
Remove the battery pack from the machine
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
For Battery tools
The ambient temperature range for the use and
storage of tool and battery is 0
o
C-45
o
C.
The recommended ambient temperature range for
the charging system during charging is 0
o
C-40
o
C.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater , VIC 3153,
Australia
To Next Page
Loading...
Need help?
General
