Copyright © 2015, Positec. All Rights Reserved.
AR01018601
www.worx.com
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug
on the power supply first.
2. If the drill doesn’t work properly, check the drill bit
for sharpness, replace drill bit if worn. Check that
the drill is set to forward rotation for normal use.
3. If a fault can not be rectified, return the tool to an
authorized dealer for repair
To Previous Page
Loading...
