10
Installing The Battery Pack See Fig.A3
Tool-Less Blade Fitting See Fig. B
Safety On/Off Switch See Fig. C
Variable Speed Control See Fig. D
Pivoting Blade Foot Adjustment See Fig. E
Pendulum action control
WARNING: Make sure the
pendulum setting is “0 “
when using the saw blade teeth
facing up.
See Fig. F
Wood Cutting See Fig. G
Metal Cutting See Fig. H
Plastic / Aluminum Cutting See Fig. I
Flush Cutting See Fig. J
Pocket Cutting (Soft Materials
Only)
See Fig. K
LED light See Fig. L
WORKING HINTS FOR YOUR
CORDLESS RECIPROCATING
SAW
Always use a blade suited to the material and
material thickness to be cut. The quality of cut will
improve as the number of blade teeth increase.
Always ensure the work-piece is firmly held or
clamped to prevent movement. Support large panels
close to the cut line. Any movement of the material
may affect the quality of the cut. The blade cuts on
the upward stroke and may chip the uppermost
surface or edges of your work piece when cutting,
ensure your uppermost surface is a non-visible
surface when your work is finished.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
To Next Page
Loading...
Need help?
General
