14
Cordless Circular Saw WX530 WX530.9
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
operating the on/off
switch.
Battery pack not securely fitted
into tool.
Battery pack is not charged.
Make sure battery is fully charged and
securely fit into the tool.
Charge the battery pack.
Cutting depth is less
than that is set.
Sawdust accumulated at the rear
of the base.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Blade spins or slips Blade is not tightly engaged with
the spindle.
Remove the blade, and reassemble it as
described in Saw blade assembly and
removing section.
Blade will not cut a
straight line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Blade kicks back when
beginning a cut
Blade is not spinning fast enough Allow the saw blade to reach full speed
prior to beginning a cut in the material.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater, VIC 3153, Australia
To Next Page
Loading...
