13
5-in-1 Multi Sander
EN
Charging the Battery Pack
See Fig.
D1,D2,D3
Installing the Battery Pack
See Fig. E
OPERATION
Switching On/Off
See Fig. F
Using the Variable Speed Dial
(Speed settings 1-6)
- The Variable Speed Dial can be used
to set the optimum speed according
to the sanding plate used and the
respective application.
See Fig. G
Application
Sanding
paper
Speed
Sanding
down
varnishes
180…400 3-6
Sanding paint 40…120 4-6
Touching up
paintwork
120…240 1-5
Sanding
wood
60…240 1-6
Machining
veneer
180…240 3-5
Derusting
metal
40…120 4-6
Sanding
metal and
steel
120…240 4-6
Sanding
curved
surface
60…240 1-6
Removing the Battery Pack
See Fig. H
Emptying the Dust Bag
-For more efficient operation, empty
dusts bag every 5-10 mins.
See Fig.
I1-I2
WORKING HINTS FOR YOUR
MULTISANDER
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speed. Always use sand
paper that is suitable for the material you want to sand.
Always ensure the work-piece is firmly held or clamped
to prevent movement.
Any movement of the material may affect the quality of
the sanding finish.
Start your sander before sanding and turn it off only
after you stop sanding. For the best results, sandwood
in the direction of the grain.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away it will
damage the base-plate. The guarantee does not cover
base-plate wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces andfine grit for the final
surfaces. If necessary, first make a test run on scrap
material.
Use only good quality sandpaper.
The sandpaper controls the sanding efficiency, not
the amount of force you apply tothe tool. Excessive
force will reduce the sanding efficiency and cause
motor overload. Replacing the sandpaper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted for
environmentally friendly recycling. The plastic
components are labeled for categorized recycling.
To Next Page
Loading...
Need help?
General
